What is the process of stopping flow blood from a broken vessel?

Steps for Stopping Flowing Blood from a Broken Vessel

1. Apply Direct Pressure:

- The best way to deal with a broken vessel and the bleeding that follows it is to apply direct pressure on the wound.

- Use a clean, absorbent piece of cloth or a bandage and apply it firmly to the bleeding site.

- Maintain steady pressure until the bleeding stops.

2. Elevate the Injured Area:

- Raise the injured area above the level of the person's heart if possible.

- This helps reduce blood flow to the area, which can slow down the bleeding.

3. Apply Pressure Points:

- If the bleeding doesn't stop with direct pressure and elevation, try applying pressure to a pressure point near the injury.

- Common pressure points include the wrist, behind the knee, or on the side of the neck.

- Hold the pressure point for a few minutes until the bleeding stops.

4. Use a Tourniquet (only as a last resort):

- A tourniquet should only be used as a last resort if the bleeding is severe and other methods have failed.

- Tightly tie a belt, scarf, or piece of cloth around the limb above the injured site, but not too tight as to cut off all circulation.

- This method should only be temporary until professional help arrives.

Seek Professional Help:

- If the bleeding is severe, doesn't stop within 15 minutes of continuous direct pressure, or if the injury is deep, it's important to seek medical attention immediately.

Additional Tips:

- Always wash your hands before touching a wound to prevent infection.

- Try to keep the wound clean and covered with a bandage or cloth at all times.

- Avoid any activities that may put pressure on the wound or cause further bleeding.