Instructions for the Evolutions Digital Vaporizer

Digital vaporizers are used to heat medical marijuana to the point of vaporization, without releasing harsh smoke. They provide precise control over the heat that medical marijuana is exposed to during the vaporization process. Evolutions Digital Vaporizers are designed to help medical marijuana patients get the most out of their medicinal herbs by maximizing the amount of THC (the therapeutic chemical in medical marijuana) they can consume. In addition to accurate control over temperature, the simple design of Evolutions Vaporizers makes them easy for everyone to use effectively. Keep your Evolutions Vaporizer clean and clear of debris for optimal performance.

Things You'll Need

• Paper towel
• Rubbing alcohol
• Dish soap
• Warm water

Show More

Instructions

• 1

  Break up the herb into very small pieces. Place a small amount (about a 1/4 gram, or more depending on your needs) in the glass fill chamber located at the end of the breathing tube.

• 2

  Connect the Evolutions Vaporizer to a power source. Flip the small switch on the side of the base to turn the vaporizer on.

• 3

  Insert the tube, glass chamber end first (this is the end that you placed the medicinal herb in), into the vaporizer. Apply light pressure until the glass chamber clicks into place. Pull air through the rubber end of the tube until you can taste the herb. Raise the temperature if there is no vapor coming through the tube, and lower it if you are inhaling harsh smoke. Aim to keep the air in the chamber between 380 and 420 degrees Fahrenheit.

• 4

  Flip the power switch to the 'Off' position and remove the tube from the base when you are done using the vaporizer. Unplug your digital vaporizer. Discard the used herb in the glass fill chamber. Lightly dampen a paper towel with rubbing alcohol and wipe down the outside and inside of the glass fill chamber. Rinse with warm, soapy water and dry it before your next use.