How to Set the Respironics M Series
Things You'll Need
- Respironics M Series CPAP Machine
- Power Supply
- Flexible Tubing
- Grey Foam Filter
- Disposable Ultra Fine Filter (Optional)
- Mask
- Electrical Outlet
- Side Table
Instructions
-
Set-Up
-
1
Your machine has been pre-set by your durable medical equipment company, based on your physician's specifications.
Place the Respironics M Series CPAP machine on a side table within 3 feet of the bedside and near an appropriately grounded electrical outlet. Plug one end of the AC power cord into the power supply, then the other end into an electrical outlet. Plug the power supply cord into the CPAP machine power outlet located above the filter, located at the back of the CPAP machine.
-
2
Locate, then attach the flexible tubing to the optional white plastic swivel. Attach the swivel to the CPAP machine's air outlet located at the back of the machine, next to the power outlet. Or, attach the flexible tubing directly to the air outlet port, without the swivel.
-
3
Press the "ON" button, located on the top of the CPAP machine, located in the center of the three buttons. Attach an interface device such as a face mask, nasal prong or nasal mask to the other end of the flexible tubing. Place the mask on the face. Your device is now ready to use.
-
4
If you are using a humidifier, lift the humidifier cover and remove the water tank. Fill the tank to the fill line. Place the tank back in the humidifier chamber and close the cover. Turn the humidifier knob to the desired setting.
-
1