How to Use Baby Quasar - Baby Blue

Baby Quasar - Baby Blue is a facial skin care tool used to reduce the signs of acne and uneven skin tone by creating softer, smoother skin. It is a photo-light therapy facial that works by shining blue light wavelengths on the skin for a short period of time, leaving the skin more hydrated and with a natural glow. Baby Quasar - Baby Blue may be used to diminish acne, blemishes, bacteria, enlarged pores and scarred skin.

Things You'll Need

• Baby Quasar - Baby Blue
• Rubbing alcohol
• Cotton swabs

Show More

Instructions

• 1

  Clean the skin and determine your skin type: normal or sensitive. Baby Quasar - Baby Blue is equipped with two modes, one for sensitive skin (Orange LED) and another for normal skin (Red LED). If skin is sensitive, the device should be used on the low (Orange LED) frequency mode for the first treatment to prevent skin irritation.

• 2

  Divide the face into six regions. Visualize a vertical line drawn on the face running down the center of the nose, dividing it into two halves. Next, visualize a horizontal line just below the brow bone and another at the tip of the nose and just below the cheek bones.

• 3

  Move the wand over each section for two minutes. Begin using Baby Quasar - Baby Blue in the upper left section of the face, above the left brow bone. Move in a counter-clockwise direction to the next section after treatment of the previous section has been completed. The device is equipped with an internal timer, which will sound after two minutes.

• 4

  Press lightly, but keep contact with the skin for the entire two minutes. Baby Quasar - Baby Blue should be moved gently against the skin during each treatment interval, allowing as little light as possible to escape for the greatest therapeutic benefit.

• 5

  Change to the high (Red LED) frequency. After completing all six sections of the face, begin again above the left brow bone and repeat treatment in a counter-clockwise direction. If there are areas of special concern, treat them for an additional two minutes in the high frequency after completing the entire face a second time.

• 6

  Turn off the device and disconnect it from the power source after treatment has been completed. Disinfect Baby Quasar - Baby Blue by wiping the wand with rubbing alcohol, using cotton swabs dipped in alcohol to clean the LEDs.