How to Adjust a Rollator

A rollator is a walker that has a seat and large tires that allow you to move around. Although a rollator has more features than a regular walker, you should adjust it before you use it to avoid injury and ensure you're getting the most comfort from it. Specifically, you can raise and lower the handlebars and seat to a height that is suitable for you by removing specific screws or adjusting certain levers.

Things You'll Need

• Adjustable wrench

Show More

Instructions

Adjusting the Handlebar Height

• 1

  Place your rollator on level ground and stand behind it with your shoulders relaxed and your arms hanging loosely.

• 2

  Notice where the handlebars are in relation to the crease of your wrists. If the handlebars are above the crease, you will need to lower them. If they are below the crease, you will need to raise them.

• 3

  Remove the bolt that holds one of the rollator's handlebars in place. These bolts are usually found a few inches down the shaft of the handlebars.

• 4

  Raise or lower the handlebar until it is at the crease of your wrist when your arm is hanging loosely to your side. Re-insert the bolt and screw it loosely in place.

• 5

  Repeat Steps 3 and 4 for the other handlebar.

• 6

  Test the position of the handlebars for comfort. If they are at the appropriate height, screw the two bolts tightly in place. If they are not at the appropriate height, repeat Steps 3, 4 and 5 until they are.

Adjusting the Seat Height

• 7

  Look underneath the rollator seat for the bolts and screws or levers that hold it in place.

• 8

  Unscrew the bolts or lift up on the levers under the seat. Remove the screws if there are screws holding the seat in place.

• 9

  Lower or raise the seat to an appropriate level. Both of your feet should be firmly planted on the ground when you sit on the rollator's seat.

• 10

  Push down on the levers or re-insert the screws and bolts that hold the seat in place.