Instructions for Cleaning a Peri-Pro

Peri-Pro is an X-ray film processor that is used for producing intraoral X-rays. The shutter is released by a single button and the images are processed within the machine by stored chemicals. If left too long, the particles within the chemicals can build up on the sides of the tank. If you notice the shutter sticking, it also requires cleaning. Routine cleaning with soap and water is the primary maintenance required to keep the machine in top condition.

Things You'll Need

• Toothbrush
• Mild soap
• Water
• Lint-free cloth
• Pliers

Show More

Instructions

Shutter Cleaning

• 1

  Use pliers to pull out the three pins securing the shutter to the Peri-Pro body.

• 2

  Lift off the shutter and unhook the spring.

• 3

  Rinse the shutter under warming water.

• 4

  Dry the shutter with a lint-free cloth.

• 5

  Wipe the inside of the of the machine with a lint-free cloth.

• 6

  Hook the spring back to the shutter and insert the end of spring into the shutter hole.

• 7

  Replace the top plate, lining up the three pin holes.

• 8

  Slide the shutter release button to the right to ensure it clicks smoothly.

• 9

  Replace the three shutter pins, tapered end first.

Tanks

• 10

  Place the service tray next to the Peri-Pro unit.

• 11

  Remove the power cord from the power outlet. Pull off the cover and the film receptacle. Lift the transport unit out of the machine, allowing the chemicals to drip off the unit before completely removing.

• 12

  Rinse the transport unit with warm water to remove the chemicals and other dried residue. Make sure you are rinsing higher than the chemical line.

• 13

  Use a toothbrush to go over the crevices of the transport unit. Rinse the transport again using warm water.

• 14

  Dry the transport and surrounding machinery with a lint-free cloth.

• 15

  Empty the water tank and rinse with warm water.

• 16

  Reassemble the Peri-Pro unit reversing the actions from Step 2.