Dyson Airblade Installation
Things You'll Need
- Owner's operation manual
- Installation template
- Electric drill and appropriate bits
- Phillips screwdriver
- Screwdriver
- Level
- Pencil or marking tool
- Appropriate electrical fittings
- 6 0.25-inch screws, toggle or masonry bolts and appropriate fittings.
Instructions
-
-
1
Turn off the electrical supply. Choose a suitable location on a flat wall and place the installation template in position, following the height recommendations described in the owner's manual. Ensure it is square; using the level.
-
2
Mark the six mounting holes then drill them. Mark and drill the hole for the electrical connection. Install the electrical conduit and wire.
-
3
Fix the mounting plate securely in position using 0.25-inch fixtures.
-
4
Lay the airblade unit face up and remove the fascia fixing screws. Refer to the owner's manual for specific directions. Remove the fascia cover.
-
5
Knock out the appropriate electrical inlet hole from the back plate of the airblade. Install the electrical unit according to the manufacturer's directions, then connect the terminal blocks.
-
6
Hang the airblade onto the mounting plate then screw it securely to the wall using the four fixing holes and fixtures.
-
7
Replace the fascia cover and secure with the tamper-proof fittings.
-
8
Switch on the electrical supply and test the unit by placing your hands between the two airblades. The airflow should start immediately.
-
1