Smoke Assist Product Directions
Things You'll Need
- Smoke Assist E-cig
- Smoke Assist cartridge
- Smoke Assist USB charger
Instructions
-
-
1
Attach the Smoke Assist battery to the USB charger provided. The charger is attached by twisting the battery into it clockwise, until hand tight.
-
2
Plug the charger with the E-cig attached to any computer USB port. Turn on the computer to charge the E-cig. A light should blink on the charger while the E-cig is charging.
-
3
Allow the battery to charge for several hours. Smoke Assist suggests you charge the battery until the charge light turns green.
-
4
Unplug the charger from the USB port, then disconnect the E-cig from the charger by twisting counterclockwise.
-
5
Pull the inhaler off the atomizer. The inhaler is the portion of the E-cig that looks like a traditional cigarette's filter.
-
6
Attach a Smoke Assist cartridge to the atomizer by screwing them together using the threaded end.
-
7
Push the atomizer, with the cartridge attached, back into the inhaler.
-
8
Screw the atomizer and inhaler on the Smoke Assist battery until hand tight.
-
9
"Smoke" the E-cig as you would a traditional cigarette by sucking on the inhaler end and inhaling the vapor. The indicator light on the end of the Smoke Assist will light up to simulate the ember on a traditional cigarette.
-
10
Recharge the E-cig and replace the cartridge as needed, following the steps above.
-
1